MBTrauma, if the dealer is just swapping sensors again, ask them to verify the manifold fasteners and check for any sign of water or coolant getting into the exhaust before the new sensors go in. Repeated O2 sensor codes can point to contamination or a leak rather than the sensor itself, so replacing them without fixing the source may just reset the clock. Worth confirming the manifold fix was actually done to spec.
Midnight’s point about the adhesive is key: many ballast bags and bulkhead fittings are polypropylene/polyethylene, which most glues won’t bond reliably. The compression seal is doing the work, so prep matters—clean, flat mating surfaces, don’t overtighten, and check for weeping after the first outing. If there’s room, a backing ring or large washer can spread the load and help it stay tight.
Since you already found the trim plate sticking, I’d fix that first: verify the tab actually retracts fully and recalibrate or replace the actuator/position sensor before reshaping the FAE. A tab sitting 3/4 inch down at 18–20 mph can definitely soften the lip. Then do a controlled same-speed, same-ballast comparison with the FAE temporarily raised or removed only if that can be done safely, so you know whether the FAE is really the main culprit before your buddy starts fabricating a new plate.
Compression seal makes a lot more sense than trusting glue on plastics that don't want to bond. That Banjo fitting seems to be the actual budget fix here, assuming it stays tight.
LOL yea Wakemakers is crazy. I called them 4 times to ask about other ways to fix the bags after they told me how much they cost. To their credit they did tell me it might be possible to fix with glue or bulkheads.
Amazon did not have a good bulkhead too skinny - neither did home depot. I went ahead and bought this same Banjo one ^ from Grainger. Grinded it down (hot plastic mess) to fit inside the bag and we surfed every day that next trip Still time to tell if it's gonna be a lasting solution. I did not use that Gear Aid glue because when I chatgpt'd it, the plastic type of the banjo plus the plastic type of the bag is not a match for glue. Basically there's no adhesive that is supposed to put those materials together. The seal is the compression of the bulkhead against the bag. Fingers crossed!